Product Manual

13
2. Move the choke lever to the choke
position.
See figure below.
3. Move the throttle control to the fast
position.
See figure below.
4. Firmly hold the recoil handle, pull the
recoil rope slowly until you feel resistance,
then pull fast in one swing. .
5. If engine doesn’t start. Repeat three last
steps until it does.
6. Once engine starts to run, you must swiftly
move the choke lever to the RUN position.
7. If for some reason the rotor stops spinning,
the engine loses cutting power or a foreign
body is preventing the normal operation of
it, notice that the engine does not shut
down because the centrifugal clutch stops
transmitting power when it disengages
below 1800 RPM. Turn off the engine (as
directed below) and review the chopper to
the rotor can rotate freely again.
Stopping the engine
1. Move the throttle lever to the idle position
then turn/press the switch to the OFF
position. See figure.
2. Shut off the gas access by turning the
knob vertical to the flow.
MAINTENANCE
General recommendations:
1.Always observe safety rules when
performing maintenance.
2. The warranty on this wood chipper, does
not cover items that have been subjected
to wear, misuse or negligence of the
operator. To receive any warranty benefits;
the operator must have maintained the
equipment as indicated in this manual.
3. All settings (blade, anvil, etc.) should