Owner's Manual

Preparations before chipping

1. Carefully inspect the area where the equipment will be used.

2. Protect your eyes, always use safety glasses while operating this machine.

Otherwise, objects thrown that bounce can seriously injure your sight.

3. Use ear protection. This will protect you from the noise produced by the chipper

when you feed the material into the hopper.

4. Use work gloves with palm of leather, industrial grade rubber or industrial cotton

when you feed the material into the hopper. Before you turn on the machine,

check all bolts and accessories to ensure that the machine is in safe operating

condition. AVOID SLOPES | USE RECOMMENDED TOLERANCE

5. Perform a visual inspection of the machine in frequent intervals to check whether

the chipper has suffered any damage.

6. Maintain and replace the safety labels and instructions as necessary.



Safe Handling of Fuel

To avoid personal injury or property damage, be very careful when handling fuel. The

fuel that is used, -gasoline- is highly flammable and the vapors are explosive.

You can be seriously injured if fuel is spilled on yourself or your clothes which can

ignite. Wash your skin and change clothes immediately.



1. Use only containers approved for Gasoline.

2. Never fill containers inside a vehicle or truck. Always place containers on the

ground away from your vehicle before filling.

3. Keep the nozzle in contact with the edge of the entrance to the engine fuel tank

or container at all times until it is full at recommended engine manufacturer

specifications.

4. No smoking should take place. Turn off all cigarettes, cigars, pipes and other

sources of ignition.

5. Never refuel the engine indoors.

6. Never remove the gas cap or add fuel while the engine is hot or running . Allow

the engine to cool at least two minutes before re- fueling .

7. Never overfill the fuel tank . Fill the tank to no more than 1/ 2 inch below the base

of the neck of the thread to allow room for fuel expansion.

8. Place the fuel cap back on and tighten securely .

9. Clean up spilled fuel on the engine and equipment. Move the chipper to another

area. Wait 5 minutes before starting the engine.