Owner's Manual
8. Assemble the feed chute and tighten.
Fasteners Used on Feed Chute
8- 5/16” X 1 G2 Hex Bolts
16- 5/16” Flat Washer (front
and back)
8- 5/16” Lock Washer
8- 5/16” Hex Nut
Tools Used:
2- 1/2” Hex Wrench
Torque on Bolts 10 ft-lbs
9. To assemble the discharge chute, open up the flanges as shown in the
picture, make sure to place a little grease on the base to make the
discharge rotate smoother.
Fasteners already come pre-
assembled on the discharge
base.
Tools Used:
2-9/16” Hex Wrench
15