Product Manual

SECTION 3: ASSEMBLING YOUR CHIPPER-SHREDDER

Assembling Lateral Chute into Chipper-Shredder:

(DV\QRWURXEOH6LPSO\MXVWJUDEGHWKH6LGH+RSSH

UDQGLQVHUWLWMXVWDVWKHILJXUHVKRZV

Reuse the bolts and nuts that grounds the chute against the crate platform 3LFN a bolt –´ VTXDUHQHFN- and insert it

WKURXJKRQHRIWKHIRXUDYDLODEOHKROHV:KLOHPDLQWDLQLQJSUHVVXUHRQLWVOLSDSUHVVXUHZDVKHUDQGDQXWUHSHDWWKUHH

PRUHWLPHVZLWKWKHRWKHUKROHV'RQ¶WZRUU\\RXFDQGRLWDOOE\\RXUVHOI

x 2QFH \RXKDYHLQVHUWHGDOO EROWVDQGWLJKWHQHG WKH QXWV JHQWO\ ZLWK WKH KDQG WKHQ \RX FDQ ILQLVK WLJKWHQ ZLWK D

´KH[ZUHQFK

Tools and pieces used for this assembly:

-´6TXDUHQHFNFDUULDJHEROWV– supplied

-´3UHVVXUHZDVKHUV- supplied

-´1XWV– supplied

-´+H[7RRO:UHQFKQRWLQFOXGHG

Assembling handles at top hopper:

- 8QEROWKDQGOHV

- 5HYHUWGLUHFWLRQRIWKHKDQGOHVRWKHKDQGOHJULSLVSRLQWLQJWRZDUGVWKHRXWVLGHRIWKHPDFKLQH

7KHVHKDQGOHVFRPHVDVVHPEOHGLQWKLVZD\RQO\IRUVKLSSLQJSXUSRVHV

Tools used in this operation:

-´+H[:UHQFK

IMPORTANT: Before starting to assemble your chipper shredder,

GLVFRQQHFWWKHVSDUNSOXJZLUHIURP\RXUHQJLQHDQGJURXQGDJDLQVWLW.

Now take apart the side hopper from machine. For this

operation you need one (1) 9/16” hex wrench. Loosen bolts

that are fastening the base with the hopper. Watch your hands,

try to use mechanic’s glove if available. Repeat operation at the

other side of the hopper.

Pull the hopper with two hands as described on the figure.

Locate it in a clean, safe place.

Loosen the counter knife and place it in between the knife and

the rotor’s bore (where products comes out once cut). Tighten

again. This will help you to contain the rotor from rotating when

you apply torque to knife’s bolts when loosening up.