Product Manual

9
10
11
SECTION 2: UNPACKING YOUR CHIPPER SHREDDER
Removing Unit From Wooden Crate:
When removing the chipper from the crate, please do it so in the following way:
- Remove the outer plastic strapping, and lift the carton upwards until you only have the machine standing on
WKHEDVH
- 5HPRYHWKHSODVWLFVWUDSSLQJWKDWKROGVWKHPDFKLQHDQGFRPSRQHQWV
- Read our - How to assemble note-.2QFHUHDGSURFHHGWRDVVHPEOH
- Be cautious for plastic strapping leftovers,ZRRGFKLSVRUHGJHPHWDOSDUWVWKDWPD\SXQFWXUH
Be prepared for arrival:
- ,
I\RXZDQWWREHUXQQLQJ\RXUHTXLSPHQWLQDQKRXURUVRDIWHUUHFHLYLQJLW0DNHVXUH\RXUHDG2SHUDWRU¶V
0DQXDOILUVWDQGXQGHUVWDQGDOOJXLGHOLQHVWKHQWKLVLVDTXLFNOLVWRIWKLQJV\RXVKRXOGEX\DQGKDYHUHDG\
before attempting to operate the equipment:
o TUWRIRLO6$(
o JDOORQVRIJDVROLQHLQDQDSSURYHGFRQWDLQHU
o $IXQQHOIRUSRXULQJJDVRQWRHQJLQH¶VWDQN
o $SSURSULDWHFORWKLQJIRUFKLSSLQJDQGVKUHGGLQJOHDYHV-EUDQFKHV
o *ORYHV$OWKRXJKZHSURYLGHDSDLURIWKHP
o 6DIHW\/HQVHV:HDOVRSURYide these)
W arning:
W atch out for
screw s, and w ood
chips that could
pinch!
Loosen the counter knife and place it in between the knife and
the rotor’s bore (where products comes out once cut). Tighten
again. This will help you to contain the rotor from rotating when
you apply torque to knife’s bolts when loosening and tightening
.
Check knives. Sharpen or replace if needed. When bolting
them on the rotor , make sure the blade is not touching the
axle’s center dish. If it does and you don’t notice it; it will cause
a continuous braking on the engine, diminishing chipping
power, causing friction and undesired results.
Once finished, reposition the counter knife. We suggest that
the opening between knives and the counter knife should be at
a maximum of 3/32” or 2.4 mm. Place side hopper on the base
again and tighten. When placing front cover, you MUST FIRST
insert the pin across the full sieve and then bolt the front cover,
otherwise it will be very difficult to insert the pin. Before starting
engine, pull the recoil a few times to see everything rotates
freely and it does not make any uncommon sounds. When
ready, put the spark plug on and start.