Install Drawing

VERSION .02
VERSION .02
17) 0nce you tightened the
wheelbase and the back su-
pport, lift the unit up and
carefully place it on the wo-
oden crate. Although this
operation can be accom-
plished by one person If you
are unsure to do this by
yourself,ask someone to as-
sist you with this step.
18) Ask another person to
help you lift the unit.Whi-
le the person is lifting the
unit, place one wheel on one
of the shafts. Repeat for
the other side.
19) Insert a 5/8” flat was-
her and then secure it by in-
serting a cotter pin through
the shaft bore at the end
of the shaft.
13) Place the machine care-
fully on the floor. Although
this operation can be acom-
plished by one person, If you
are unsure to do this next
step by yourself, please ask
another person to assist you.
14)0nce the machine is placed
on the floor, please proceed
to assemble the wheelbase
and tighten with 4 - 1/4” x
1” hex bolts with their flat
washer, spring washer and
nut.
15)Take the discharge ho-
pper and place it as shown
on the picture. Place two to
three bolts to locate the
discharge hopper. Don’t put
the nuts yet .
16)Locate the back
support’s holes on the same
location as the discharge
hopper’s and make them fit
through the bolts. Screw in
the spring washers of nuts
and tighten. You will need 2 -
7/16” hex wrenches for this
operation.