Install Drawing

VERSION .02
VERSION .02
23) Fill with oil.
24) Locate the fuel cap as
shown in the picture. Fill with
3 quarts of clean fresh fuel.
25) Make sure the ‘choke le-
ver’ in on the CH0KE posi-
tion.
26) Make sure the ignition
switch is on (if available),
place the throttle at mid
position and put the fuel su-
pply knob in 0N position.
6) Unbolt the wheel base
that is attached to the
back support for packaging
purposes. If bolts are too
tight, use two 7/16” hex
wrenches.
7) Unscrew the back su-
pport with a Phillips-type
screw.
8) The machine comes atta-
ched to the wooden support
with 4 bolts , 2 by each side.
Unbolt then with the help
of two 7/16” hex wrenches.
5) Take the discharge ho-
pper and place it nearby.