Operator`s manual

Secure the handle connectors in position by
tightening each wing nut (carriage bolts must be
seated properly into the handle and grooves must
line up between connectors). Also make certain the
bottom tip of the upper handle connector in front of
the bottom tip of lower handle connector. See
Figure 5.
Marked
Lines
Wing Nut_ Carriage
Handle
Lower Connectors
Handle
Connector
Figure 5
SpindleHeightAdjustment
To adjust height of the spindle assembly proceed as
follows:
* The trimmer line is connected to the spindle disc,
which can be raised or lowered. See Figure 6.
o The spindle disc in the normal position rest on the
spindle cap approximately 2" off the ground.
o Just loosen each wing nut on spindle shaft,
because they are designed not to be removed.
- Slide spindle disc along shaft to the desired
position and tighten wing nuts to secure in position.
o The spindle disc can be adjusted from 2" to 4".
Trimmer
Base
Wing
S!
Disc
Cap Spindle
Shaft
Trimmer
Line
Figure 6
SECTION7: MAINTAININGYOURSTRINGTRIMMERMOWER
CustomerResponsibilities
/ _oO,O o,OoO O//
MAINTENANCE ,_ ,_" .__ ._ _
SCHEDULE .o_._ ,_q_ _ __-_' _o_ _o'P
LubricateWheels
Clean Trimmer Deflector _
Check TrimmerLine
Check Belt Tension
Change Oil _
LLI ReplaceAir Filter <_
Z
Clean Engine IntakeScreen _
Z
uJ Check Spark Plug _:_ <_
Check SparkArrester(if any) _ <_
SERVICE
DATES
10