STOP ARRÊT ALTO Electric Snow Thrower For problems or questions, DO NOT return this product to the store. Contact your Customer Service Agent . 31A-020-900 En cas de problèmes ou pour des questions, NE PAS retourner ce produit au point de vente. S'adresser au préposé du Service à la clientèle en composant. Para problemas o preguntas, NO devolver este producto a la tienda Contacte a su Agente de Servicio al Cliente. U.S.A. Imported by: MTD LLC P.O.
TABLE OF CONTENTS RULES FOR SAFE OPERATION Rules for Safe Operation Pages 2-7 Specifications Page 12 Operating Instructions Page 8-9 Parts List Page 13 Maintenance Instructions Pages 10-11 Notes Page 14 Troubleshooting Page 12 Manufacturer’s Limited Warranty Page 15 The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and their explanations, deserve your careful attention and understanding.
TABLE OF CONTENTS RULES FOR SAFE OPERATION Rules for Safe Operation Pages 2-7 Specifications Page 12 Operating Instructions Page 8-9 Parts List Page 13 Maintenance Instructions Pages 10-11 Notes Page 14 Troubleshooting Page 12 Manufacturer’s Limited Warranty Page 15 The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and their explanations, deserve your careful attention and understanding.
RULES FOR SAFE OPERATION MINIMUM WIRE GAUGE RECOMMENDATIONS PLEASE READ - SAVE THESE INSTRUCTIONS VOLTS When using an electrical appliance, basic precautions should always be followed to assure maximum safety and optimum performance. Read this manual before assembling and operating this appliance. Failure to comply with instructions may result in electrical shock, burns, fire, or personal injury. 120 3. 4. 5. 6. WIRE SIZE REQUIRED 18 A.W.G.* 16 A.W.G.* 16 A.W.G.* Table 1 (1).
RULES FOR SAFE OPERATION MINIMUM WIRE GAUGE RECOMMENDATIONS PLEASE READ - SAVE THESE INSTRUCTIONS VOLTS When using an electrical appliance, basic precautions should always be followed to assure maximum safety and optimum performance. Read this manual before assembling and operating this appliance. Failure to comply with instructions may result in electrical shock, burns, fire, or personal injury. 120 3. 4. 5. 6. WIRE SIZE REQUIRED 18 A.W.G.* 16 A.W.G.* 16 A.W.G.* Table 1 (1).
RULES FOR SAFE OPERATION EXPLANATION OF NOTE, WARNING, and WARRANTY SYMBOL 22. Keep clothing and body parts away from the rotor. 23. Always stop the motor when clearing snow is delayed or when walking from one location to another. 24. Disengage power to the rotor when snow thrower is transported or not in use. 25. After striking a foreign object, turn the unit off and inspect the snow thrower from damage. Unplug the unit. Repair damage before restarting and operating the unit. 26.
RULES FOR SAFE OPERATION EXPLANATION OF NOTE, WARNING, and WARRANTY SYMBOL 22. Keep clothing and body parts away from the rotor. 23. Always stop the motor when clearing snow is delayed or when walking from one location to another. 24. Disengage power to the rotor when snow thrower is transported or not in use. 25. After striking a foreign object, turn the unit off and inspect the snow thrower from damage. Unplug the unit. Repair damage before restarting and operating the unit. 26.
RULES FOR SAFE OPERATION OPERATING INSTRUCTIONS REAR HANDLE LOCK-OFF BUTTON CONNECT THE CORD POSITIONING THE ASSIST HANDLE 1. 1. 2. 2. 3. ON/OFF TRIGGER CORD RETAINER ASSIST HANDLE 4. 5. Ensure the cord is NOT plugged into a receptacle before this procedure. Make a loop with 8″ - 10″ (20 - 25cm) of the end of the extension cord. Place the loop into the slot (A) under the rear handle and lock into place on the cord retainer (B) as shown in Figure 1.
RULES FOR SAFE OPERATION OPERATING INSTRUCTIONS REAR HANDLE LOCK-OFF BUTTON CONNECT THE CORD POSITIONING THE ASSIST HANDLE 1. 1. 2. 2. 3. ON/OFF TRIGGER CORD RETAINER ASSIST HANDLE 4. 5. Ensure the cord is NOT plugged into a receptacle before this procedure. Make a loop with 8″ - 10″ (20 - 25cm) of the end of the extension cord. Place the loop into the slot (A) under the rear handle and lock into place on the cord retainer (B) as shown in Figure 1.
OPERATING INSTRUCTIONS MAINTENANCE INSTRUCTIONS OVERLOAD PROTECTION SWITCH TIPS FOR BEST SNOW THROWING RESULTS SERVICING THE UNIT This unit is equipped with an overload protection switch to protect the circuit (that the unit is plugged into) from short circuit overloads. If the switch pops out: 1. Release the bail and allow the unit to stop and cool for a minute. 2. Press the overload switch (A) to reset. Resume operation. (Fig. 5) If the switch pops again shortly after the first time: 1.
OPERATING INSTRUCTIONS MAINTENANCE INSTRUCTIONS OVERLOAD PROTECTION SWITCH TIPS FOR BEST SNOW THROWING RESULTS SERVICING THE UNIT This unit is equipped with an overload protection switch to protect the circuit (that the unit is plugged into) from short circuit overloads. If the switch pops out: 1. Release the bail and allow the unit to stop and cool for a minute. 2. Press the overload switch (A) to reset. Resume operation. (Fig. 5) If the switch pops again shortly after the first time: 1.
MAINTENANCE INSTRUCTIONS REPLACING THE PLATE CLEANING Use only original equipment manufacturer replacement parts. To avoid serious personal injury, always turn your unit off and unplug it before you clean or service it. WARNING: To avoid serious personal injury, always turn your unit off and unplug it before you perform maintenance. WARNING: 1. 2. 3. 4. Use a small brush to clean off the outside of the unit. Do not use strong detergents.
MAINTENANCE INSTRUCTIONS REPLACING THE PLATE CLEANING Use only original equipment manufacturer replacement parts. To avoid serious personal injury, always turn your unit off and unplug it before you clean or service it. WARNING: To avoid serious personal injury, always turn your unit off and unplug it before you perform maintenance. WARNING: 1. 2. 3. 4. Use a small brush to clean off the outside of the unit. Do not use strong detergents.
PARTS LIST NOTES 1 45 2 3 4 5 6 44 7 8 48 51 53 46 6 10 11 43 9 12 42 6 47 13 52 14 15 6 41 54 40 39 16 17 18 38 50 37 19 36 49 6 35 34 20 21 22 23 24 16 25 26 27 28 29 17 30 55 31 32 33 No. Parts No. Description No. Parts No.
PARTS LIST NOTES 1 45 2 3 4 5 6 44 7 8 48 51 53 46 6 10 11 43 9 12 42 6 47 13 52 14 15 6 41 54 40 39 16 17 18 38 50 37 19 36 49 6 35 34 20 21 22 23 24 16 25 26 27 28 29 17 30 55 31 32 33 No. Parts No. Description No. Parts No.
STOP ARRÊT ALTO Electric Snow Thrower For problems or questions, DO NOT return this product to the store. Contact your Customer Service Agent . 31A-020-900 En cas de problèmes ou pour des questions, NE PAS retourner ce produit au point de vente. S'adresser au préposé du Service à la clientèle en composant. Para problemas o preguntas, NO devolver este producto a la tienda Contacte a su Agente de Servicio al Cliente. U.S.A. Imported by: MTD LLC P.O.
