Use and Care Manual

8 se c t i O n 3 — as s e M b l y & se t -up
Chipper Chute (Model Series 460)
Remove the three cupped washers and hex nuts from 1.
weld studs around the opening on the side of the impeller
housing. See Fig. 3-5A.
Remove the hex bolts, flat washers, and lock nuts from the 2.
two holes on the upper end of the support brace. See Fig.
3-5B.
Align the chipper chute over the weld studs, so the slot in 3.
the bottom of the chute is facing down. See Fig. 3-6A.
Remove the hex lock nut, spacers, and hex bolt from the 2.
top of the impeller housing. See Fig. 3-3B.
Align the chute deflector in position on the discharge 3.
opening and insert hex bolt with spacer through hinge on
chute deflector (spacers fit inside of hinges). See Fig. 3-4A.
Place second spacer over hex bolt inside other hinge and 4.
secure with hex lock nut. See Fig. 3-4B.
Secure both sides of chute deflector to impeller housing 5.
using wing knobs previously removed. See Fig. 3-4C.
B
A
B
A



A
B
C