Use and Care Manual

Controls and Features
4
10
Chipper Chute
Allows twigs and small branches up to 3” (2” for Model Series
450) in diameter to be fed into the impeller for chipping. See Fig.
4-1.
Hopper
Allow leaves and small branches up to 1/2 diameter to be fed into
the impeller for chipping and shredding. Material can be raked
into the hopper by lowering it down to the ground.
Release Rod
The release rod is located on the impeller bracket assembly and it
is used to release or lock the hopper when raising or lowering.

Tow Bar (If Equipped)
Use the tow bar to tow the chipper shredder behind a tractor to a
job site. See Fig. 4-1.
NOTE: If your unit is not equipped with a tow bar, you may
contact Customer Support as instructed on page 2 for
information regarding price and availability.
Recoil Starter
The recoil starter is located on the engine. Pull the recoil starter
to start engine.
Engine Controls
See the engine Owner/Operator manual packed with your unit
for the location and function of the controls on the engine.
e
Hopper
Tow Bar†
own
