PARTS & FEATURES 4. Start Lever Aver on handle which allows the engine fo run. When lever is released, engine will stop Choke Control Restricts the air intake. This allows for an enriched fuse-air mixture which hips to slant the engine. Rifler Location uf engine exhaust.
Fahd and follow the assembly instructions. Do not discard any parts or materials until the unit is assembled. References to the right or left side of the edger are from the viewpoint of the operator's position behind the edger.
WARNING! Flame out wires MUST be connected for correct engine operation. Failure to connect can result in serious injury. How to Remove Edger from Carton 1. Ramos all parts and packaging components. 2 Use a utility knife to out all 4 vertical edges and lay the side panels fiat around the edger. 3 Remove any remaining packaging 4. Roll the unit out from the carton, and place on a hard level surface. How io Assemble the Handle NOTE: Regor to Figure 2 when following steps below: 1.
ENGINE PREPARATION Engine Gil 5A CAUTION Engine shipped without oil Failure to add oil will result in serious engine damage. Abbott of SAE 30 engine oil is included with your Edgar. Re far to the chart on the right for alternative oil types fo use at different TEMP = a temperatures. Always use a high quality defendant oil classified “For Service, 8G, CAUTION Am biped Sevres Acanthus SH, SJ” or higher. Do not uss special additives. Always use recommended ofl ype.
cutting depth {Ses Figure 7), and check that the frame of the cadger is level. 2 Removes the il fil capitalistic and wipe titan with cloth. {Sea Figures 3} 3. Insert dipstick into fil spout but do NOT screw in. Remove dipstick and chad oil revel 4. When oil level is ful, the oll will be at upper limit on dip stick. if oll level is near or below the lower limit, ofl must bs added. (See Figure 4) &. Add oil slowly until the ofl level reaches the upper limit of the dipstick.
