Product Manual
15
Before starting engine, read operator’s manual. Become familiar with
location and function of all controls. Know how to stop the engine quickly.
Before starting the engine, check that the ameout wire terminals have
been connected.
Before attempting to start the engine, review the following steps:
1. Unit has been assembled according to all assembly instructions.
2. Flameout wire terminals are connected.
3. Unit has been inspected for any damaged or missing components.
4. No parts are remaining in the carton.
5. Engine oil is at proper level.
6. Fresh, clean, regular-unleaded gasoline has been added to fuel tank.
7. Spark plug wire is connected to spark plug.
8. Edger has been moved to desired location.
9. Edger is on level surface.
Keep all bystanders, especially CHILDREN, away during operation.
This unit’s engine exhaust system is equipped with a spark-
arresting mufer. Tampering with or removing the spark-arrestor violates section
4442 of the California Public Resources Code as well as other applicable state
and federal law.
Never Run engine indoors or in a poorly ventilated area. Engine exhaust
contains Carbon Monoxide, an ODORLESS and DEADLY gas.
Debris thrown from edger can cause severe eye damage. Always wear
ANSI compliant safety glasses or eye shields when operating edger. If you
wear eyeglasses, put an OSHA certied Wide Vision Safety Mask over
your eyeglasses.
1. Review ALL steps in the “BEFORE STARTING THE ENGINE” section.
2. Always move the Depth Control Level to the Start Position when start the
engine every time. Keep the blade leave the ground before you start the