Use and Care Manual

15
housing and the new shave plate is 2-4 mm
above the ground. Tighten securely.
To remove and replace your snowblower's auger
belt, proceed as follows:
1. Remove the belt cover on the front of the
engine by removing the two self-tapping
screws. (See Fig.21).
Fig. 21
Drain the gasoline from the snowblower,
or place of plastic under the gas cap.
2. Carefully pivot the snow thrower up and forward
so that it rests on the auger housing. Remove
the frame cover from the underside of the
snowblower by removing four self-tapping
screws which secure it. (See Fig.22).
Fig. 22
3. Loosen and remove the shoulder screw of
the belt keeper.(See Fig.23).
Fig. 23
4A. Roll the auger belt off the engine pulley(See
Fig.24A)
4B. Unhook the support bracket spring from the
frame(See Fig.24B)
Fig. 24A
Fig. 24B
5. Remove the belt from around the auger
pulley, and slip the belt between the support
bracket and the auger pulley. Reassemble
auger belt by above instructions in reverse
order. (See Fig.25).