Use and Care Manual

14
Fig. 17
The gear (hex) shaft (FIG.18A) should be
lubricated at least once a season or after every
25 hours of operation.
1. Remove the lower frame cover by removing
the two screws which secure it.
2. Apply a light coating of an all-weather multi-
purpose grease to the hex shaft. (See FIG.18).
Fig. 18
Avoid oil spillage on rubber friction
At least once a season, remove both wheels.
Clean and coat the axles with a multipurpose
automotive grease before reinstalling wheels.
At least once a season, remove the shear pins on
auger shaft. Spray lubricant inside shaft, around
found at either end of the shaft. (See Fig.19).
Fig. 19
and sealed at the factory. If disassembled from
any reason, lubricate with 160g of new grease.
to the seals could result. Be sure the vent plug is
free of grease in order to relieve pressure.
The shave plate and skid shoes on the bottom of
the snowblower are subject to wear. They should
be checked periodically and replaced when
necessary.
1. Remove the four carriage bolts and hex
snowblower. (See Fig. 20)
2. Reassemble new skid shoes with the four
carriage bolts (two on each side) and hex
Fig. 20
1. Remove the carriage bolts and hex nuts
which attach it to the snowblower housing.
2. Reassemble new shave plate, making sure
heads of carriage bolts are to the inside of