Use and Care Manual

12
Fig. 13
The throttle control is located on the engine.
It regulates the speed of the engine and will shut
off the engine when pushed down to the end
(tortoise) completely. (See Fig.13)
Fig. 14
The auger control is located on the right handle.
Squeeze the control grip against the handle
to engage the augers and start snow throwing
action. Release to stop. See Figure 14.
Fig. 15
The drive control is located on the left handle.
Squeeze the control grip against the handle to
engage the wheel drive. Release to stop. See
(See Fig.15.)
This snow blower has EXCLUSIVE Simultaneous
Engagement System for one-hand operation and
Built-in auto-turn power steering system, this
technology enables effortless power steering on
your snowblower. This system is able to sense
the direction your trying to turn the snowblower
and engages the drive system to assist turning in
the desired direction.
Fig. 16
The chute directional control is located on the
panel of the snowblower.
To change the direction in which snow is thrown,
turn chute directional control as follows:
Crank control joystick clockwise to discharge to
the right.
Crank control joystick counterclockwise to
discharge to the left.(See Fig. 16).
Manually operate the control lever forward and
backward. The more backward the position, the
higher the height of snow is thrown.(See Fig.16)
Located on control panel. Turn ON to
illuminate the headlight LED and OFF to
douse.
Heating Handle Switch
located on control panel. Turn ON to heat both
operation handles and OFF to stop.
Position the skid shoes based on surface
conditions. Adjust upward for hard-packed snow.
Adjust downward when operating on gravel or
crushed rock surfaces.This machine is equipped
with plastic and steel skid shoes for different
surface.
This handle is used to manually start the engine.
Requires the use of a two-prong outdoor
extension cord and a 120V power source.
This machine is not equipped with an
extension cord.
LED Headlight Switch