Use and Care Manual

26
Hotline: [phone]
the starter handle slowly a few times to distribute oil. Pull recoil slowly until resistance is felt. This will
close the cylinder valves.
WARNING
！
Do not attach spark plug wire to spark plug when storing the unit.
4. Clean tiller. Remove all dirt, leaves, debris, grease, etc. from the tiller — including cylinder cooling fans,
recoil starter cover holes, under fuel tank, and under mufer.
5. Check the tiller for worn or damaged parts. Have damaged parts replaced if necessary.
6. Tighten any loose hardware.
7. Apply lubrication as directed in Maintenance section.
8. Put the unit in a building that has good ventilation.
9. Cover the tiller with a breathing material.
TRANSPORTING THE TILLER
Empty the gas tank. Always let the engine run until it has used up the remainder of gas in the tank.
Empty the engine oil from the warm engine. Remove the spark plug cover from the spark plug. Clean the
cooling ns of the cylinder and the housing. Use the original packaging to ship whenever possible.
TROUBLE SHOOTING
WARNING
！
Before performing any maintenance or cleaning work, switch off the engine and wait until the blade has
come to a stop.
CAUTION
Improper repairs can result in the product functioning unsafely. This endangers yourself and your
environment.
Faults which cannot be rectied with the aid of the following table may require service by an authorized
Yard Force repair center. Please be aware that any improper repairs will also invalidate the warranty and
additional costs may be incurred.
MAINTENANCE AND STORAGE