Use and Care Manual

23
Hotline: [phone]
MAINTENANCE AND STORAGE
CAUTION
Important notes about maintenance schedule:
1. Re-check tightness of all fasteners after rst 2 hours of initial use
2. Change engine oil after rst 5—8 hours of initial use
3. Change oil every 25 hours if operating under heavy load or in high temperatures
4. Clean air lter every 10 hours if operating under dusty conditions.
WARNING
！
Use only GENUINE replacement parts. Other parts may damage the unit or result in injury.
SERVICING THE TILLER
The following information will help you make the necessary checks and perform the procedures required to
follow the normal care recommendations made for your tiller unit. If you prefer, your local authorized dealer
can make these checks and perform the required procedures for you.
WARNING
！
To prevent accidental starting (See Fig.13):
Engine must be turned off and cool. The spark plug wire must be removed and secured from spark plug
before checking and adjusting engine or equipment.
Fig. 13
CHANGING BELT (See Fig.14)
1. Turn off engine. Engine must be cool completely before proceeding.
2. Remove the spark plug wire and secure from the spark plug.
3. Remove the belt cover by using wrench to loosen 4pcs bolts.
4. Slide the belt free of the engine pulley.
5. Pull the belt down and away from the transmission pulley.
6. Install new belt:
Place the belt around the transmission pulley in groove.