Use and Care Manual

26 27
Hotline: [phone] Hotline: [phone]
1. Ensure the main power switch is turned OFF. Clean the underside as instructed.
2. Set the Autonomous Mower to the lowest cutting height.
3. Turn the mower upside-down. Remove the 5 screws fixing the battery compartment's lid. Note one
screw is partially covered by the blade protector and is only accessible through a service hole.
4. Pull out the battery and disconnect it from the Autonomous Mower.
5. Carefully clean the lid and the edge of the battery compartment. Debris may allow excessive water to
enter the battery compartment, causing major damage to the appliance.
6. Connect and insert the replacement battery, close the compartment and fix the lid with 5 screws. Do not
turn on the Autonomous Mower before placing it back on its wheels. Beware of sharp blades!
Cleaning the underside
Ensure the main power switch is in OFF position. Wearing protective gloves, turn the Robotic Mower onto
its side to expose its underside. Clean the blade disc and frame using a soft brush or damp cloth. Rotate
the blade disc to make sure that it can move freely, check that the blades can turn on their pivots and that
there is no grass is obstructing them.
O
F
F
0
1
O
N
Clean the contact pins and the charging strips
Using wire wool, metal cleaner or very fine grade emery paper, clean the contact pins and the charging
strips on your mower and docking station. Remove any debris, leaves, or grass clippings around the contact
pins and charging strips to ensure efficient charging.
Reversing or replacing the blades
WARNING
！
Ensure the Robotic Mower is completely shut off before cleaning, adjusting or replacing the blades.
Always wear protective gloves.
WARNING
！
To ensure maximum cutting efficiency and safety, always use recommended replacement blades and
blade mounting parts when replacing.
MAINTENANCE AND STORAGE
Your Robotic Mower has three blades, fixed to the blades disk.
Unless damaged by hard obstacles, these blades can last for up to five months of everyday use.
Weekly inspection of the blades and the fixing screws is advised. Note that the blades are double-edged.
When the first side becomes blunt, loosen the fixing screw and the blade upside down and re-fix. Check
that the blade can move freely.
A set of spare blades is included with the Robotic Mower. More blades can be purchased via customer
support.
To ensure you get the best performance from your machine, always replace all three blades at the same
time. Only use spare parts recommended by manufacturer.
NOTE: if blades have been removed/ changed, please ensure that the screw is firmly secured in place
and that the blade is free to move.
Spare parts list
In case you need spare parts or any support with your device, please call our after sales centre.
MAINTENANCE AND STORAGE