User's Manual

1. Get a slotted screwdriver. Insert the tip of the
screwdriver into the slot of the Back Cover. With a little
twist, pry the Back Cover open.
2. Replace the old battery with the new battery gently. Then push the Back
Cover back until all 3 tabs are inserted securely.
BATTERY REPLACEMENT
09
BASE UNIT AND EXPANSION UNIT
04
WEARING
Arm Band Pass through
the Arm Band Loops
By Arm Band
(Recommended)
By Belt Clip
There are two types of Yapalong-6000 units: Base Unit and Expansion Unit. A
Base Unit has its own talking slot, while an Expansion Unit must share the two
talking slots of the group with other Expansion Units.
A Yapalong-6000 group can consist of purely Base Units (up to 7), or mixed
Units: Base Units (up to 5) plus Expansion Units (unlimited). A group cannot
consist of only Expansion Units. The binding methods are slightly different for
the two types of groups.
A Base Unit can be used with either an open MIC or PTT (push-to-talk)
headset, while an Expansion Unit must be used with a PTT headset.
The user needs to select the Base/Expansion type when placing the order.
PTT State of A Base Unit
The Open MIC or PTT state of a Base Unit is controlled by the Unit itself not
by the paired headset. Open MIC is the default state.
Press the Bluetooth button once to activate the PTT state, and the Settings
light is turned on.
Press the Bluetooth button again to deactivate the PTT state, and the Settings
light is turned off.
BINDING
Binding needs to be done under a minimal radio interference environment,
which means no cellphone, no computer, no Bluetooth, and no electrical
control panel nearby. After binding, there is NO need to do binding again next
time for the same group, until new radio(s) are added to the group.
To bind a group, each unit of the group needs to be set into Binding mode. To
set a unit into Binding mode, press the Group button while holding down the
Settings button for 3 seconds, the Group light and the Battery light begin to
flash alternatively. After 5 or more seconds, both lights stop blinking. Both
Group light and Battery light will be solid, or only Group light will be solid
depending on the sequence of Binding. The radios in Binding mode cannot
communicate.
Face of no font
is facing outside