User's Manual

Doc No: 890-03084 Date: 2017-02-13 Rev 02pa1

Yanzi Networks Installation Manual – Smart Office 12 of 19

6. Placement of Sensors

General tips on placement

• Try to place the sensors in discrete locations

• Place sensors along walls at about

150-170 cm (60-70 inches) from floor

• Sensors are attached using screws or adhesive tape

• Target wood, plastic, or metal surfaces that are flat

• Avoid wall papers as they may break if sensor must be removed

• Avoid painted walls when using adhesive tape as modern paint is efficient in repelling adhesive

tape

• Remove tape cover and press firmly ON THE SLEEVE for 10 seconds. After 10 seconds, the

adhesive tape is strong enough to hold the sensor. Full adhesiveness is reached after 72 hours.

Yanzi Motion+

• Place on wall of smaller rooms such as conference rooms and phone booths

• Place in ceiling above groups of 4-8 work desks

Yanzi Comfort

• Place on wall not close to work desk

• Requires a power outlet within 0.5 meters (longer cables available as accessory)

Yanzi Presence for work desks

• Place under work desk about an arm’s length from edge

Yanzi Presence for conference room chairs

• Place under conference room table at each chair about an arms length from edge

Yanzi Presence for conference room corner

• Place in corner of smaller rooms and along walls in larger rooms

• Face away from windows to avoid direct sunlight

• Face away from door to avoid detecting people walking outside the room

• Use multiple sensors for large rooms (>20m

)