Service manual

FUEL INJECTION PUMP
10. Tighten the link lifter retainer bolt
12. Install a new O-ring (Figure 5-89, (1)) to the
(Figure 5-87, (1)) to 6- 7 ft-lb (8 - 10 N.m). stop solenoid and install the stop solenoid to
OD01 304a
Figure 5-87
11. Install the governor housing screws and tighten
to 6 - 7 ft-lb (8 - 10 N-m) (Figure 5-88).
0001305a
Figure 5-88
the governor housing. Tighten the solenoid
bolts to
6 - 7 ft-lb (8 - 10 N-m).
0001 306a
Figure 5-89
13. Pre-set the adjustment of the angleich . .
assembly, by loosing the angleich lock nut
(Figure 5-90, (1)).
0001 306C
Figure 5-90
14. Turn the angleich adjustment screw in until it
contacts the governor lever and then back out
one-quarter
(114) turn.
15. Tighten the angleich lock nut.
YANMAR. MP series service Manual
5-37