Service manual

FUEL INJECTION PUMP
3. With the distribution shaft gear touching the
4. Install the camshaft bearing retainer and bolts
pump body, insert the camshaft into the body.
(Figure 5-49, (1)) and tighten to 6 - 7 ft-lb.
During installation prevent the cam lobes from (8 - 10 N.m).
hitting the distribution shaft gear and the
- .
camshaft key from hitting the camshaft bushing.
(Figure 5-48).
Note: 4-cylinder camshafts require special care
during reassembly due to tight
tolerances.
0001 239
Figure 5-48
Figure 5-49
VANMAR. MP series service Manual
5-25