Specifications

The remote control handles and the engine control levers are connected by an accelerator cable. Over
time the cable becomes stretched and the connections loose causing deviation in the position, which
makes operation unsafe. Inspect the cable periodically and adjust if necessary.
1. Adjusting the Governor Remote Control Handle
Check to see that the speed lever on the engine side is touching the high speed limiting
bolt when the governor handle is put in H ( High Speed ).
Check to see that the speed lever on the engine side is touching the low speed limiting
bolt when the governor handle is put in L ( Low Speed ).
If the speed lever does not touch the limiting bolt for either the high or low speed, when
you check them, loosen the setting screws on the fittings for the accelerator cable and
adjust the position of the cable.
2. Adjusting the Clutch Remote Control Handle for the Marine Gear
Check to see that the clutch lever on the engine side is in the neutral position when the
remote control handle is in NEUTRAL.
If the position of the clutch lever is incorrect, loosen the setting screw of the cable.
Check the clutch lever in
! FWD ( Forward )
" REV ( Reverse )
making sure it is correctly aligned.
Make any necessary adjustments using NEWTRAL as the central point.
Inspection • • every 250 hours
5. Principal specifications
5.1 Specifications
Engine Model 1GM10 2GM20(F) 3GM30(F)
Idling speed min-1 850±25
High idling speed min-1 3825±25