Specifications
Table Of Contents
- Table of Contents
- Introduction
- Safety
- Product Overview
- Before You Operate
- Engine Operation
- Periodic Maintenance
- Introduction
- Safety Precautions
- Precautions
- EPA Maintenance Requirements
- Periodic Maintenance Schedule
- Periodic Maintenance Procedures
- Daily Checks
- After Initial 50 Hours of Operation
- Every 50 Hours of Operation
- Every 100 Hours of Operation
- Every 150 Hours of Operation
- Every 250 Hours of Operation
- Draining the Fuel Tank
- Replacing the Engine Oil Filter Element
- Changing the Marine Gear Oil
- Checking or Replacing the Seawater Pump Impeller
- Cleaning the Intake Silencer (Air Cleaner) Element
- Cleaning or Replacing the Exhaust / Water Mixing Elbow
- Adjusting the Alternator V-ribbed belt Tension
- Cleaning the Breather Pipe
- Checking the Wiring Connectors
- Every 1000 Hours of Operation
- Troubleshooting
- Long-Term Storage
- Specifications
- System Diagrams
- EPA Warranty USA Only
- Emission System Warranty
ENGINE OPERATION
48 YM Series Operation Manual
CHECKING THE ENGINE
AFTER OPERATION
• Check that the power switch is off and
that the battery switch (if equipped) is
turned to off.
• Fill the fuel tank. See Filling the Fuel
Tank on page 29.
• Close seawater cock(s).
• If there is a risk of freezing, check that
the cooling system contains enough
coolant. See Engine Coolant
Specifications on page 34.
• If there is a risk of freezing, drain the
seawater system. See Drain Seawater
Cooling System on page 80.
• At temperatures below 0°C (32°F), drain
seawater system and connect the
engine heater (if equipped).
YM OPM_EN.book 48 ページ ２０１３年６月７日 金曜日 午前１１時１１分