Specifications

BEFORE YOU OPERATE
36 YM Series Operation Manual
Figure 3
Figure 11
1 – Filler Cap Tabs
2 – Coolant Filler Cap
3 – Filler Port Notches
4 – Coolant Tank / Heat Exchanger
4. Pour coolant slowly into the coolant
tank / heat exchanger (Figure 11, (4))
to avoid air bubbles. Fill until coolant
overflows from the filler port.
NOTICE
Never pour cold coolant into a hot
engine.
5. Align the filler cap tabs (Figure 11, (1))
with filler port notches (Figure 11, (3))
and tighten the filler cap
(Figure 11, (2)) .
Figure 4
Figure 12
1 – Rubber Hose to Coolant Tank
2 – FULL Mark
3–LOW Mark
4 – Reservoir cap
6. Check the coolant level in the
reservooir. The level should be at the
FULL mark (Figure 12, (2)).
Note: The coolant level rises in the
reservooir during operation.
After stopping the engine, the
coolant will cool down and the
extra coolant will return to the
coolant tank.
NOTICE
Never pour cold coolant into a hot
engine.
7. Remove reservoir cap (Figure 12, (4))
to add coolant if necessary. Do not add
water.
8. Replace the filler cap and tighten it
firmly. Failure to do so will cause
coolant to leak.
054720-00X00
1
2
3
4
Reservoir Capacity
0.8 L (0.8 qt)
LOW
FULL
4
1
2
3
0004493
YM OPM_EN.book 36 ページ ２０１３年６月７日 金曜日 午前１１時１１分