Specifications

BEFORE YOU OPERATE
YM Series Operation Manual 33
12/05
MARINE GEAR OR SAIL
DRIVE OIL
Marine Gear Oil Specifications
Use marine gear oil that meets or exceeds
the following guidelines and classifications:
KM2P-1 (S), (G) or (GG):
• API Service Categories: CD or higher
• SAE Viscosity: #20 or #30
Sail Drive Oil Specifications-
SD20
Refer to the Sail Drive Operation Manual
for the procedure to fill or replace the sail
drive oil.
SD20:
• API Service Category: GL4.5
• SAE Viscosity: 90 or 80W90
Checking Marine Gear Oil
Figure 7
1–Dipstick
(Filler cap combined type)
2 – Marine Gear Filler Port
3 – Upper Limit
4 – Lower Limit (Dipstick end)
1. Make sure the engine is off. Make sure
the engine is as level as possible and
wipe area clean around the marine
gear filler port (Figure 7, (2)).
2. Remove the filler cap at the top of the
housing.
3. Remove the dipstick (Figure 7, (1)) and
wipe with a clean cloth.
4. Re- insert the dipstick without screw in,
please see illustration (Figure 7).
5. Remove the dipstick. The oil level
should be between the upper
(Figure 7, (3)) and lower
(Figure 7, (4)) lines on the dipstick.
6. Screw in the dipstick.
Adding Marine Gear Oil
1. Make sure the engine is as level as
possible.
2. Remove the filler cap at the top of the
housing.
NOTICE
Never overfill the marine gear with oil.
3. Fill with oil to the upper limit on the
dipstick (Figure 7, (3)). See Marine
Gear Oil Specifications on page 29.
4. Screw in the dipstick.
5. Hand-tighten the filler port cap.
Checking and Adding Sail Drive
Oil
Refer to the Sail Drive Operation Manual
for the procedure for checking and filling
the sail drive oil.
054316-00X00
1
2
3
4
3
4
YM OPM_EN.book 33 ページ ２０１３年６月７日 金曜日 午前１１時１１分