Specifications
Table Of Contents
- Table of Contents
- Introduction
- Safety
- Product Overview
- Before You Operate
- Engine Operation
- Periodic Maintenance
- Introduction
- Safety Precautions
- Precautions
- EPA Maintenance Requirements
- Periodic Maintenance Schedule
- Periodic Maintenance Procedures
- Daily Checks
- After Initial 50 Hours of Operation
- Every 50 Hours of Operation
- Every 100 Hours of Operation
- Every 150 Hours of Operation
- Every 250 Hours of Operation
- Draining the Fuel Tank
- Replacing the Engine Oil Filter Element
- Changing the Marine Gear Oil
- Checking or Replacing the Seawater Pump Impeller
- Cleaning the Intake Silencer (Air Cleaner) Element
- Cleaning or Replacing the Exhaust / Water Mixing Elbow
- Adjusting the Alternator V-ribbed belt Tension
- Cleaning the Breather Pipe
- Checking the Wiring Connectors
- Every 1000 Hours of Operation
- Troubleshooting
- Long-Term Storage
- Specifications
- System Diagrams
- EPA Warranty USA Only
- Emission System Warranty
PRODUCT OVERVIEW
YM Series Operation Manual 23
12/05
Accessory power output
The harness attached to the panel has a terminal where the signal that is synchronized to
the panel power supply can be taken off. (Figure 13) ( Refer to the Wiring Diagrams on
page 94.)
The maximum current of this output terminal is 3 A. Do not use a current higher than 3 A.
For the content of the output terminal, refer to the Wiring Diagrams on page 94.
Figure 3
Figure 13
043801-00E00
F1A - 3 AMP Fuse
Buzzer
ACC Output
YM OPM_EN.book 23 ページ ２０１３年６月７日 金曜日 午前１１時１１分