Instruction manual

35
VG3511-8F
7. Trimming mechanism
Fig. 7-3
7.2 Adjusting suction pipe(front)
Fig. 7-4
7.3 Adjusting suction pipe cover
Set right-and-left position of the suction pipe(front) ②
about 5 ㎜ apart from the left side of the chip receiver ④ .
Loosen the screw ③ to adjust the position of the suction
pipe(front) ② or remove it.
☆ Suction by compressed air:
Adjust the suction power with the speed controller ① .
Keep the pressure to a minimum for suctioning the
chips.
☆ Suction by vacuum system:
Connect the 󲻼exible hose to the vacuum dust collector
to adjust the suction power.
Keep the pressure to a minimum for suctioning the
chips.
Adjust the position of the suction pipe cover ⑤ after
changing the position of the suction pipe(front) ② .
(1) Loosen the screws ⑥ on the suction pipe cover ⑤ .
(2) Align the right side of the suction pipe cover ⑤ with
the inlet of the suction pipe(front) ② .
(3) Tighten the screw ⑥ securely.
⑤
⑥
If tightened the screw ③ excessively, the suc-
tion pipe(front) ② may be deformed. That may
be difficult to adjust or remove it.
①
②
③
④
5㎜
ＡＤＶＩＣＥ