Instruction manual

13
VG3511-8F
①
②
④
⑤
③
D
E
A
A
A
B
C
5. Proper operation
5.3 Threading
☆ Looper thread
Pull the thread until the knot is out. Then, cut off the knot.
Note: Threading for sewing with UT or UT-A device
Note: For easy threading, pull the lever ②
of the thread take-up eyelet holder
① .
After threading, push the lever ②
to reset the thread take-up eyelet
holder ① to the original position.
Fig. 5-4
☆ for stretch able thread
* For standard type of thread, thread through the looper
thread eyelet(left) ④ via the looper thread release ③ .
(Thread D)
* For stretchless thread, thread directly to the looper ⑤
through the looper thread release ③ . (Thread E)
Never thread through
top cover tension disc
A: Needle thread
Pull out the threads until they come to the front of the needles. Then, cut off the knots before passing them
through the needle eyes.
Thread correctly for the left needle which is in the inmost position as shown in the 󲻻gure.
When threaded, rethread by tying new threads with the preset threads.
When not threaded, thread correctly as shown in Fig. 5-4.
C: Spreader thread
Pull the thread until the knot comes out.
B: Looper thread
Pull the thread until the knot comes out. Then, cut off the knot.
with UT or UT-A
device