Instruction manual
2. Installation
8
VG3511-8F
2.8 Accessories
Install the accessories as the suction pipe(rear), the suction pipe support, the exible hose and the speed con-
troller on the machine as follows:
(1) Install the speed controller ⑧ in the screw hole on the bottom of the lower knife holder.
(2) Insert the suction pipe(rear) ① into the hole of the bottom of the lower knife holder bracket ② and x them
with the screw ③ .
(3) Remove the screws ④ at the rear of the machine frame.
(4) Install the suction pipe support ⑤ with the screws ④ at the place the screws ④ were located.
(5) Install the suction pipe(rear) ① on the suction pipe support ⑤ .
(6) Insert the exible hose ⑦ tted with the hose band ⑥ into the suction pipe(rear) ① . Then, x them with
the hose band ⑥．
Fig. 2-12
If tightened the screw ③ excessively, the suction pipe(rear) ① may be deformed. That may be difficult to remove
it when clogged with chips.
①
②
③
④
⑤
⑥
⑦
⑧
Ａ
ＮＯＴＩＣＥ