Specifications

YCO-1047-03-13
PPC-200(W) Operation Manual
Setting the Analog Meter
1) Press and hold the key for 2-3 seconds. The display will
show the current under setpoint.
2) Press the key to select the digit you want to change.
The underscore will move to the right.
3) Press the or keys to set the desired value.
4) Repeat steps 2 and 3 until the entire number is set.
5) Press the key again to save the displayed under setpoint
and to display the current over setpoint.
6) Press the key to select the digit you want to change.
7) Press the or keys to set the desired value.
8) Repeat steps 6 and 7 until the entire number is set.
9) Press the key to save the displayed upper setpoint and
to return to normal weighing mode.
This sets the register A setpoints. To set the register B or register C
setpoints, begin by holding the or key in step 1.
V Optional Analog Meter
9