User Manual

21
Specification
Model IJ100
Operating temperature range
0 to 60
℃ (room temp: 20℃, no load)*
Temperature adjustment accuracy
±0.3℃ (the center of inner bath, set temp.:37℃)
Temperature distribution accuracy
±1.0℃ (the center of inner bath, set temp.:37℃)
Temperature rising time Approx. 40min. (20 to 60°C)
Performance
Temperature falling time Approx. 100min. (20 to 0°C)
Heating device Mica heater 120W
Cooling device
Two peltier cells, forced radiating method:
It works continuous at the setting temperature below 35
℃.
(It is turned off at the setting temperature 35
℃ and over.)
Configuration
Internal fan Axial fan (DC)
Controller Hitec IV
FR
type1
Temperature control system PID control of heater output by microcomputer
Temperature setting system
Digital Setting by
▼▲ (up/down) Keys
Operational mode Fixed temperature operation
Sensor Thermistor
Control Section
Additional function
Temperature preset function (1 for desired temperature is able to
set/load)
Self-diagnostic function
Sensor error, Heater error, Triac error, Main relay error, Auto
overheating prevention
Safety
Device
Preservation device
Earth leakage breaker, Independent overheating prevention
device
External dimensions
350(W)
×396(D)×535(H) mm
Internal dimensions
250(W)
×250(D)×250(H) mm
(Air jacket installed: 200
×200×200 mm)
Internal capacity 15.6L
Door
Single door with magnet packing
(the direction of opening/closing is changeable)
Weight Approx. 20kg
Standard
Power supply 100V AC 50/60Hz 3.5A
Accessories
Shelf
×2 (Load: 5kg for each), Plate for drainage, Instruction
manual
Optional accessories
Extra shelf (with metal fittings), Air jack et made of aluminum (with
shelf)
 The values shown on “Performance” are in power supply 100V AC.
 Usable ambient temperature for this unit is 5 to 30℃.