Manual

14
Indication after Step/Step Procedure Explanation
7.
Switching the sub display information.
Push the MENU
MENUMENU
MENU key to set the sub display
screen switching mode.
Switched to the latest measured temperature.
Switched to the ongoing program.
Switched to the remaining time.
When the start time is up, the
STANDBY
lamp goes
out and HC200 starts the program operation.
When the start time is up, the sub display shows the
latest parameters.
Ex: In the example shown on the left, HC200 is on the
first segment of Program 2, and the remaining
time of the segment is 10 seconds.
(During the program operation.)
! On the sub display screen switching mode, you can
check 3 pieces of information; the remaining time
before the ongoing segment finishes, the preset
temperature, and the ongoing program number.
See “Changing Sub Display Screens” on page 22.
8. When the program operation finishes
HC200 stops regulating the temperature.
The main display shows the latest measured
temperature.
The sub display flashes the word
.
The
HEAT
lamp goes out.
The
PROGRAM
lamp stays lit.
(Preset temperature in use)
(Program number in use)
(Segment number on process)
(Remaining time of the
ongoing segment)