Manual

38
Operation Method
Program Creation Method
2
Edit step
• Refer to the page 55 for the temperature rise/fall time.
They vary depending on the sample used or condition of exhaust opening (open or close). Check
them by conducting operation.
• The conception of repeat is shown in the figure below. The first operation of repeat interval is not
counted as a repeat count.
Step No. S04
Start step: S02
Repeat times : 5
Step No. S01
No repeat
instruction
Step No. S02
No repeat
instruction
Step No. S03
No repeat
instruction
Step No. S05
No repeat
instruction
5 repeating
of interval
Program creation example;
1
Program creation; Step 1 (S01)
TROUBLE
ENTER
CANCEL
DOO
R
Select step S01
Program OPR
Set TEMP
► 0℃
S01
Set TEMP ► 0min
S01
① Press the PROGRAM key. The program menu starts
and step number selection screen is displayed.
② Press the ENTER key. The setting temperature
selection screen is displayed.
③ Press the ENTER key. The setting temperature edition
screen is displayed. Set "100℃" using the "▼▲" and
press the ENTER key to decide it.
④ Press the PROGRAM key. The setting period selection
screen is displayed.
⑤ Press the ENTER key. The setting period edition
screen is displayed. Set "25min" using the "▼▲" and
press the ENTER key to decide it.