Manual

36
Operation Method
Program Creation Method
The program pattern below is explained as an example.
- Program pattern example -
Temp
200℃
100℃
0℃
Step S01 S02 S03 S04 S05 S06 S07 S08 S09
Temp.(℃)
100 100 150 150 200 200 50 50 -
Time(min.)
25 30 15 30 0 30
2:30
30 End
Fan speed
10 5 8 8 10 8 10 5
OFF
Rep. start
No No No No No No S01 No -
Rep. count
- - - - - - 1
← Repeat function →
Repeat the steps S01 to S07 once
- -
1
Select operation mode
• Check that the power in turned on.
PROGRAM
TROUBLE
ENTER
CANCEL
DOO
R
Select step S01
Program OPR
① Press the PROGRAM key. The program menu
starts and step number selection screen is
displayed.
Press the "▼▲". The registered step numbers
and the smallest number of un-used step are
displayed in sequence. Select the step number
among them.
 The "S01" is displayed if no program is registered.
In this case, the "▼▲" are invalid.
② Press the ENTER key. The selected step
number is decided and the select the setting item
selection screen is displayed. The "Set TEMP"
is displayed at the beginning.
③ Press the CANCEL key to cancel the program
menu.