Instruction Manual

36
Operation Method
RS485 Communication Function
7. List of Identifiers/Commands
<Identifiers and set values>
*1: "_" means a space.
*2: The setting range depends on other parameters. (See the table shown below.)
*3: A parameter with which a W command is valid during each operation (valid during operation in
regular mode).
Fixed-value operation parameters
Name Identifier Command Set value
Temperature setting SV1 R/W
SLL
～ SLH ： Set value limiter lower limit - set value
limiter upper limit ℃ (*2,
*3)
Store command
Name Identifier Command Set value
Store set value SV1 R/W
None
(This command is required to store temperature and
time settings.)