Owner`s manual

Click on the "Envelope" tab to access the Attack Rate, Delay, and Release envelope
parameters. The Decay parameter is only available when the Pluck driver is selected. Each of
these parameters can be adjusted from -16 to +16 (33 steps). The higher the value the faster
the rate. A value other than "0" must be selected to produce any effect. With some DRIVER and
PIPE/STRINGS combinations, however, only positive or negative values can be selected. Also,
some envelope settings will produce no audible effect with some DRIVER and PIPE/STRINGS
combinations.
(d) Control
Click on the "Control" tab to access parameters that allows adjustment of Breath Controller
operation. The "Control depth" parameter can be adjusted from 0 (no control) to 127 (maximum
depth), and the "Control curve" parameter can be adjusted from -16 to +16 (33 steps). Positive
values produce a softer curve while negative values produce a harder curve. The "Breath/No
Breath" parameter selects the breath control source: "Breath" for the Breath Controller, or "No
Breath" for touch EG control (i.e. keyboard velocity and aftertouch response).
(e) Tweak
The "Tweak 1" and "Tweak 2" tabs access a range of parameters that can be adjusted from
-16 through +16 (33 steps). Additional parameters may also appear according to the selected
patches.
- 13 -