Specifications

3.2.2 Scene Control Comman
d
3) SCN: Used when a scene is recalled.
Comman
d
Optio
n
SCN [AMP ID] [Scene #]
The command name stands for "Scene."
The TXn/ACD1 will send the command when a scene is recalled.
- If sending from a TXn, [AMP ID] is always 0. If sending from an ACD1, [AMP ID] is the AMP ID (0 to 39) assigned to the amp to be controlled.
- [Scene #] will have an appropriate character string.
- A space will be needed between the command and the option, and between the options.
E.g.) If scene 8 is recalled, the TXn sends the following string to the controller.
SCN 0 8
3.2.3 Amp Connection Status Command (ACD1
)
7) CON: Used when an amp connection is established or los
t
Comman
d
Optio
n
CON [AMP ID] [Amp Connection Status
]
The command name stands for "Connection."
This command only applies to ACD1 firmware V1.12 or later.
The ACD1 will send the command when an amp connection is established or lost.
- [AMP ID] is the AMP ID (0 to 39) assigned to the amp to be controlled.
- [Amp Connection Status] will have a character string of either "ON" when connected or "OFF" when disconnected.
- A space will be needed between the command and the option, and between the options.
- The command is not available for the TXn.
E.g.) If the amp with AMP ID #2 is newly connected, the ACD1 sends the following string to the controller.
CON 2 ON
3.2.4 Identify Control Comman
d
8) IDENT: Used when Identify is switched on or off.
Comman
d
Optio
n
IDENT 0 [Identify ON/OFF
]
The command name stands for "Identify."
This command only applies to TXn firmware V1.30, ACD1 firmware V1.12, or later.
The TXn/ACD1 will send the command when Identify is switched on or off.
- The first option is always 0.
- [Identify ON/OFF] will have a character string of either "ON" or "OFF."
- A space will be needed between the command and the option, and between the options.
E.g.) If Identify is switched ON, the TXn/ACD1 sends the following string to the controller.
IDENT 0 ON
TXn/ACD1 Remote Control Protocol Specifications V1.12
4