User Manual
Table Of Contents
- Contents
- Introduction
- Charging and Powering
- Bluetooth® Connectivity
- Wearing This Product
- Operation (Audio Playback and Phone Calls)
- Dedicated Application
- Troubleshooting
- Read this first
- Cannot connect
- Multi-point connection unavailable
- Power will not turn on
- The product cannot be charged
- The product does not operate or play back
- No sound can be heard
- Sound can only be heard from one earbud
- Sound is not good or sounds strange
- The sound is distorted, noisy or choppy
- Using only one of the earbuds
- Initializing (performing a factory reset)
- Updating the firmware
- List of support centers
- Appendix
Pairing with a Different Device
Follow the steps below to pair with another Bluetooth device, or to try pairing with the same device again.
Up to three Bluetooth devices can be registered with this product. If you pair a device beyond the maximum
number, the information for device you first paired (the oldest pairing) will be deleted.
[Search tag] #Q02 Pairing
1 Remove the earbuds from the charging case.
The earbuds will turn on.
2 With earbuds (L) and (R) turned on, long-tap the Touch Control on earbud (L) and
on earbud (R) at the same time for about three seconds, and then release your
fingers.
Either earbud (L) or (R) will be the primary earbud, and its indicator alternately flashes while
you hear the message “Pairing”. This means that the earbud is in pairing standby mode.
Flashes
3 sec
Earbud that is now primary
3 Activate Bluetooth on the Bluetooth device.
A list of Bluetooth devices that can be connected will be shown.
21
Bluetooth® Connectivity > Pairing with a Different Device