User Manual
Table Of Contents
- Contents
- Introduction
- Charging and Powering
- Bluetooth® Connectivity
- Wearing This Product
- Operation (Audio Playback and Phone Calls)
- Dedicated Application
- Troubleshooting
- Read this first
- Cannot connect
- Multi-point connection unavailable
- Power will not turn on
- The product cannot be charged
- The product does not operate or play back
- No sound can be heard
- Sound can only be heard from one earbud
- Sound is not good or sounds strange
- The sound is distorted, noisy or choppy
- Using only one of the earbuds
- Initializing (performing a factory reset)
- Updating the firmware
- List of support centers
- Appendix
Bluetooth® Connectivity
Pairing for the First Time
When first connecting this product to a Bluetooth device (such as a smartphone), follow the steps below to
pair (register) this product with that device.
[Search tag] #Q02 Pairing
NOTE
Remove the earbuds from the charging case the first time you use this product, and peel off the isolation sheets found on each.
1 Remove the earbuds from the charging case.
The earbuds turn on; and when both earbuds automatically connect, an audio message is
played. Either earbud (L) or (R) will be the primary earbud, and its indicator lights up as shown
in the illustration below as the unit enters pairing standby mode. You will hear the “Pairing”
audio message in the earbud. Either earbud (L) or earbud (R) can become the primary earbud.
Lights up for 1 sec
Flashes
Lights up for 1 sec
Earbud that is now primary
2 Activate Bluetooth on your Bluetooth device.
A list of Bluetooth devices that can be connected will be shown.
19
Bluetooth® Connectivity > Pairing for the First Time