User Manual

THR30II Wireless THR10II Wireless THR10II Reference Manual 9
Connection
 Charging the built-in battery (THR-II Wireless only)
Connect the supplied power adaptor to the DC IN jack located on the rear side of the THR-II Wireless. The LED
of the power button lights in green while charging.
* For further details of the Power Button LED state, refer to the THR30II Wireless, THR10II Wireless* Power Button LED status
list (page 17).
NOTICE
• When you use the THR-II Wireless in an environment of extreme temperatures, charging may not be
possible.
• Charge the built-in rechargeable battery once every six months to maintain the function.
 Charging the Relay G10T (THR-II Wireless only)
Connect the Relay G10T *
1
to the [INPUT] jack located on the top of the THR-II Wireless. The built‐in recharge-
able battery starts *
2
charging automatically. If you have disconnected the Relay G10T from the [GUITAR] jack of
the THR-II Wireless and want to resume charging, wait for more than two seconds before reconnecting the
device to the [GUITAR] jack.
*
1
Refer to the manual of Relay G10T for explanations of LED display indications on the Relay G10T.
*
2
If the supplied power adapter is not connected to the THR-II Wireless, charging of the Relay G10T will not start.
NOTICE
• After charging, unplug the Relay G10T from the THR-II Wireless.
• When the THR-II Wireless is turned off and the power adapter is connected, the Relay G10T is
charged by simply connecting. However, the THR-II Wireless is set to stop supplying power to the
Relay G10T when the Relay G10T charging is finished. In this state, leaving the Relay G10T con-
nected to the THR-II Wireless may result in depletion of the Relay G10T’s battery power. Turn off the
THR-II Wireless’s ECO setting to prevent this.
 Changing the Relay G10T’s ECO setting *
1
*
2
1. Switch on the power of THR-II Wireless
2. Switch off the power of THR-II Wireless while holding the [TAP/TUNER] button
*
3
*
1
You can change the ECO setting from the THR Remote.
*
2
ECO on and ECO off are toggle. When you change the ECO setting, perform the steps 1 to 2 again.
*
3
Since the ECO setting changes to ECO off when charging is started on the Relay G10T, “C” will appear on the LED
display.
Connecting to guitar by wireless (THR-II Wireless only)
The THR-II Wireless can connect with the Relay G10T wireless guitar transmitter (made by Line 6) by wireless.
Moreover, the optimal channel is set automatically by connecting the Relay G10T to the [INPUT] jack located on
the top of the THR-II Wireless for at least 10 seconds. For details on wireless connection, refer to the Relay
G10T’s manual.
Switch off the power while
holding the [TAP/TUNER]
button.