Owner`s manual

3 En
PREPARATION
REMOTE CONTROL AND FRONT PANEL
9 BAND
Selects the reception band (DAB, FM, or AM).
0 AUTO SCAN
Starts the automatic scanning function (see pages 6, 12).
A A (standby/on)
Turns on this unit. Press this button again to set this unit to
the standby mode.
y
The standby/on indicator lamp above lights up when this unit is
turned on.
In the standby mode, this unit consumes a small amount of power
in order to receive infrared signals from the remote control.
B TUNING H / I
• Selects the desired frequency when you press this
button.
• Searches the next FM or AM station when you press
and hold this button for more than 2 seconds.
C FUNCTION
Activates the function set up menu (see pages 8, 13).
D CLEAR
• Clears a preset station (see pages 8, 13).
• Clears all station information and preset settings in the
DAB tuning mode when you press and hold this button
for more than 3 seconds (see page 9).
• Clears all preset stations in the FM or AM tuning mode
when you press and hold this button for more than 3
seconds (see page 13).
E STEREO indicator
Lights up when this unit is in the stereo playback.
F TUNED indicator
Lights up when this unit is tuned into a station.
G Multi-information display
Displays tuning status messages and the DAB station
information.
H SECONDARY indicator
Lights up when this unit is in the DAB tuning mode and
receiving a secondary station.
I TUNING MODE
Selects the tuning mode (automatic, manual, or preset
tuning).
J PRESET/TUNING
• Searches the next FM or AM station when this unit is
in the automatic tuning mode.
• Selects the desired frequency when this unit is in the
manual tuning mode.
• Switches the preset stations when this unit is in the
preset tuning mode.
■ Using the remote control
Use the remote control within 6 m (20 ft) of this unit and
point it toward the remote control sensor. It receives
signals from a remote control provided with a Yamaha
amplifier or AV receiver.
• Do not spill liquid on the remote control.
• Do not drop the remote control.
• Do not leave the remote control in the following places:
– hot or humid places such as a bathroom or near heater
– extremely cold places
– dusty places
■ Installing the battery in the remote
control
Change the battery when the operation range of the remote
control decreases.
• Keep the battery out of the reach of children, so that it
is not mistakenly swallowed.
• Insert the battery according to the polarity markings.
Note
Notes
CAUTION
30º 30º
Approximately
6 m (20 ft)
Remote control
sensor
Straight pin
Battery (CR2025)
(supplied)