User Manual

Item Description
• If port error is detected : (by err-
disable)
Hardware is Interface type (e.g., Ethernet, VLAN)
HW addr Physical (MAC) address *1
Description Description of interface
ifIndex Interface index number
MRU Maximum Receive Unit *4
ARP ageing timeout
ARP timeout time (time that ARP
entries are maintained) *3
Speed-Duplex
Speed and duplex mode settings, and
operating status *1
Auto MDI/MDIX Auto MDI/MDIX enabled/disabled *1
IPv4 address
IP address/mask length *3 (shown only
if IP address is set)
broadcast
IP broadcast address *3 (shown only if
IP address is set)
input
packets Number of packets received *2
bytes Number of bytes received *2
multicast packets Number of multicast packets received *2
drop packets
Number of overflowed packets received
*2, *5
output
packets Number of packets transmitted *2
bytes Number of bytes transmitted *2
multicast packets
Number of multicast packets transmitted
*2
broadcast packets
Number of broadcast packets
transmitted *2
drop packets
Number of tail-dropped packets
transmitted *2, *5
*1 Shown only for physical interface
*2 Shown only for physical interface and logical interface
*3 Shown only for VLAN interface
*4 In the case of logical interface and VLAN interface, shows the minimum value for the physical interface belonging to that
interface
*5 Shows the transmission information when tail dropping is enabled, and the information only for reception when tail dropping
is disabled.
[Example]
Show the status of LAN port #1.
SWP1#show interface ge1
Interface ge1
Link is UP
Hardware is Ethernet
HW addr: 00a0.de00.0000
Description: Connected to router
ifIndex 1, MRU 1522
Speed-Duplex: auto(configured), 1000-full(current)
Auto MDI/MDIX: on
Interface counter:
input packets : 320
bytes : 25875
multicast packets: 301
output packets : 628
92 | Command Reference |
LAN/SFP port control