User Manual

10.1.5 Set cross/straight automatic detection
[Syntax]
mdix auto
no mdix auto
[Initial value]
mdix auto
[Input mode]
interface mode
[Description]
Enables cross/straight automatic detection. If this is enabled, the necessary cable connection type (straight or cross) is
automatically detected, and the connection is specified appropriately.
If this is executed with the "no" syntax, automatic detection is disabled, and MDI is used.
[Note]
This command can be specified only for LAN port.
When this command is used to change the settings, link-down temporarily occurs for the corresponding interface.
[Example]
Disable cross/straight automatic detection for LAN port #1.
SWP1(config)#interface ge1
SWP1(config-if)#no mdix auto
10.1.6 Set EEE
[Syntax]
power efficient-ethernet auto
no power efficient-ethernet auto
[Initial value]
no power efficient-ethernet auto
[Input mode]
interface mode
[Description]
Enables Energy Efficient Ethernet (EEE).
If this command is executed with the "no" syntax, EEE is disabled.
[Note]
This command can be specified only for LAN port.
When this command is used to change the settings, link-down temporarily occurs for the corresponding interface.
[Example]
Enable EEE for LAN port #1.
SWP1(config)#interface ge1
SWP1(config-if)#power efficient-ethernet auto
10.1.7 Show EEE capabilities
[Syntax]
show eee capabilities interface ifname
[Parameter]
ifname : LAN port interface name
Interface to show
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Shows whether the specified interface supports EEE.
88 | Command Reference | LAN/SFP port control