User Manual

Chapter 10
LAN/SFP port control
10.1 Basic settings
10.1.1 Set description
[Syntax]
description line
no description
[Parameter]
line : Single-byte alphanumeric characters and single-byte symbols (80 characters or less)
Description of the applicable interface
[Initial value]
no description
[Input mode]
interface mode
[Description]
Specifies a description of the applicable interface. If this command is executed with the "no" syntax, the description is deleted.
[Example]
Specify a description for LAN port #1.
SWP1(config)#interface ge1
SWP1(config-if)#description Connected to rtx1210-router
10.1.2 Shutdown
[Syntax]
shutdown
no shutdown
[Initial value]
no shutdown
[Input mode]
interface mode
[Description]
Shut down the applicable interface so that it is not used.
An interface for which this command is specified will not link-up even if it is connected.
If this command is executed with the "no" syntax, the applicable interface can be used.
[Note]
This command can be specified only for LAN/SFP port and logical interface.
It is not possible to change a VLAN interface when it is in the no shutdown state.
If this command is applied to logical interface, the settings of all LAN/SFP port units belonging to that interface are changed.
[Example]
Shut down LAN port #1 so that it is not used.
SWP1(config)#interface ge1
SWP1(config-if)#shutdown
10.1.3 Set speed and duplex mode
[Syntax]
speed-duplex type
no speed-duplex
86 | Command Reference | LAN/SFP port control