User Manual

SWP1(config)#snmp-server enable trap coldstart
Disable traps.
SWP1(config)#no snmp-server enable trap
9.1.3 Set system contact
[Syntax]
snmp-server contact contact
no snmp-server contact
[Parameter]
contact : Name (maximum 255 characters) to register as the system contact
[Initial value]
no snmp-server contact
[Input mode]
global configuration mode
[Description]
Sets the MIB variable sysContact.
sysContact is a variable that is typically used to enter the name of the administrator or contact.
If this command is executed with the "no" syntax, the setting is deleted.
[Example]
Set the system contact to "[e-mail]".
SWP1(config)#snmp-server contact [e-mail]
9.1.4 Set system location
[Syntax]
snmp-server location location
no snmp-server location
[Parameter]
location : Name to register as the system location (maximum 255 characters)
[Initial value]
no snmp-server location
[Input mode]
global configuration mode
[Description]
Sets the MIB variable sysLocation.
sysLocation is a variable that is generally used to enter the installed location of the unit.
If this command is executed with the "no" syntax, the setting is deleted.
[Example]
Set the system location as "MainOffice-1F".
SWP1(config)#snmp-server location MainOffice-1F
9.1.5 Set SNMP community
[Syntax]
snmp-server community community ro_rw [interface ifname]
no snmp-server community community
80 | Command Reference | Network monitoring