User Manual

[Parameter]
interface : VLAN interface name
[Initial value]
telnet-server interface vlan0.1
[Input mode]
global configuration mode
[Description]
Sets the VLAN interface that allows access to the Telnet server.
If this command is executed with the "no" syntax, the specified interface is deleted.
This command can be used to specify up to eight items, which are applied in the order that they are specified.
If this command has not been used, all access is prohibited.
[Note]
If service telnet-server is not specified, this command does not function.
[Example]
Allow access to the Telnet server from the hosts connected to VLAN #1 and VLAN #2.
SWP1(config)#telnet-server interface vlan0.1
SWP1(config)#telnet-server interface vlan0.2
8.1.4 Restrict access to the TELNET server according to the IP address of the client
[Syntax]
telnet-server access action info
no telnet-server access [action info]
[Parameter]
action : Specifies the action for the access condition
Setting value Description
deny "Deny" the condition
permit "Permit" the condition
info : Specifies the transmission-source IPv4 address or IPv6 address that is the condition.
Setting value Description
A.B.C.D Specifies an IPv4 address (A.B.C.D)
A.B.C.D/M
Specifies an IPv4 address (A.B.C.D) with subnet
mask length (Mbit)
X:X::X:X Specifies an IPv6 address (X:X::X:X)
X:X::X:X/M
Specifies an IPv6 address (X:X::X:X) with
subnet mask length (Mbit)
any Applies to all IPv4 addresses and IPv6 addresses
[Initial value]
none
[Input mode]
global configuration mode
[Description]
Restrict access to the TELNET server according to the client terminal's IPv4/IPv6 address.
Up to eight instances of this command can be set, and those that are specified earlier take priority for application.
If this command is set, all access that does not satisfy the registered conditions is denied.
However, if this command is not set, all access is permitted.
Command Reference | Remote access functions | 73