User Manual

Chapter 8
Remote access functions
8.1 Telnet server
8.1.1 Start Telnet server and change listening port number
[Syntax]
service telnet-server [port]
no service telnet-server
[Parameter]
port : <1-65535>
Listening port of the Telnet server (if omitted: 23)
[Initial value]
service telnet-server
[Input mode]
global configuration mode
[Description]
Enables the Telnet server. You can also specify the listening TCP port number.
If this command is executed with the "no" syntax, the function is disabled.
[Example]
Start the Telnet server with 12345 as the listening port number.
SWP1(config)#service telnet-server 12345
8.1.2 Show Telnet server settings
[Syntax]
show telnet-server
[Input mode]
priviledged EXEC mode
[Description]
Shows the settings of the Telnet server. The following items are shown.
• Telnet server function enabled/disabled status
•
Listening port number
• VLAN interface that is permitted to access the TELNET server
• Filter that controls access to the TELNET server
[Example]
Show the settings of the Telnet server.
SWP1#show telnet-server
Service:Enable
Port:23
Interface(vlan):1, 2, 3
Access:
deny 192.168.100.5
permit 192.168.100.0/24
8.1.3 Set host that can access the Telnet server
[Syntax]
telnet-server interface interface
no telnet-server interface interface
72 | Command Reference |
Remote access functions