User Manual

[Input mode]
priviledged EXEC mode
[Description]
Reboots the system.
[Note]
If the currently-running settings (running configuration) have been changed from the settings at the time of boot (startup
configuration), reboot will discard those changes. Therefore, if necessary, you should execute the copy running-config
startup-config command or the write command before you execute the reload command.
[Example]
Reboot the system.
SWP1#reload
reboot system? (y/n): y
4.10.3 Initialize settings
[Syntax]
cold start
[Input mode]
priviledged EXEC mode
[Description]
Reboots with the factory settings.
[Note]
You must enter the administrator password when executing this command.
[Example]
Initialize the settings.
SWP1#cold start
Password:
4.10.4 Set default LED mode
[Syntax]
led-mode default mode
no led-mode default
[Parameter]
mode : Default LED mode
Setting value Description
link-act LINK/ACT mode
status STATUS mode
vlan VLAN mode
eco ECO mode
[Initial value]
led-mode default link-act
[Input mode]
global configuration mode
[Description]
Set the default LED mode.
When you execute this command, the LEDs are lit in the specified mode. The LEDs are lit in the specified mode even when a
loop is detected in STATUS mode and the loop status has been resolved.
If this command is executed with the "no" syntax, the setting returns to the default.
Command Reference | Maintenance and operation functions | 53